2004 GMC Sierra "time" Questions

how to set timing on 1995 gmc sierra where is the timing connector located use inductive timing light, hook up to battery, place clamp over #1 plug wire, clean off timing marks on damper, & metal ...

timing Timing, 89 GMC Ignition timing connector. I disconnected my timing bypass connector. to time my truck. Set Timing to 4 degrees btdc. When I reconnected my bypass connector the mark on my damper

ignition timing i removed the distrubator shaft from my 1996 gmc pickup. i have put it in place a 1000 times ,but it will not run. i need to find the correct procedure for installing the distrubator ...

when i disconnect the tan/black wire to set timing engine will not hold steady idle. is this normal? NO it should just stop the spark advance .Look at the cam and crank pisition sensors More then ...

tengo una gmc la sierra 1500 5.7 vortec ano 1997 le acavo de reparar el motor pero no la puedo poner a tiempo Clean off the crankshaft pulley at the front of the engine and put some paint on the ...

...step by step procedure to do it. Remove spark plug cylinder #1 place cylinder end of compression time. Crankshaft pulley timing mark at 0 degree remove distributor cap then find on the cap where

Were is the connector to disconnect for ignition timing 89 gmc sierra You have to disconnect the brown wire thats on the firewall. It disables the computer controlled advance and allows you to set the

...you cant adjust the timing. However if you have a faulty knock sensor the PCM cant tell the proper time to fire. The knock sensor picks up on ignition ping and adjust the time to send spark to the ...

turns over getting fuel and spark but will not start. put new starter on vehicle, wasn't the issue if you have fuel and spark and no bang,better check the timing,your pistons have to compress ...

trying to set timing on 91 sierra 1500 ext cab pickup have had to replace almost everything the truck just slowly died back fired real bad but now I am having problems setting the timing right inspect