4x4 not working won't come out of 4 low ,no lights on switch encoder motor sensor or encoder motor disconnect battery for a full 3 minutes and retry if it shifts encoder motor sensor is out
...it could be any # of causes, but these are notorious for bad conections at the transfer case encoder motor and /or the encoder motor itself.The motor,when replaced may need to be
...and o/d and now the push button transfer case doesn't want to work. Hi, the transfer case has an encoder motor , that shifts it. When a problem occurs, it can go haywire, and make it so it will
...is causing the grinding sound. Don't go tearing into this yet! It could be your transfer case encoder motor if it is wearing out it could be making a lot of noise when trying to shift. And if
...driving in 2WD. You need to let us know the codes it has. I'd bet it has a C0327, which is your encoder motor. They are not cheap, just a little
Just replaced my encoder motor, front actuator, and dash switch....altough the transfer case engages it won't stay in 4 wheel drive for long you may have to replace your trasfer case control module ...
...my 1997 GMC Suburban transmission started slaming into gear and code 1846. That code is for an encoder motor(shift motor) on the transfer case.Not difficult to change but expensive to buy(200 ...
...sometimes doesn't show color in 2 wheel drive. I have seen problems in both the dash switches and encoder motors on the side of the transfer case. You need to have the 4x4 module scanned for
where is the 4x4 encoder sensor located on my 2004 sierra 1500 Most times it's right underneath the dashboard by the gas pedal.
635 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions