1997 GMC Sonoma "oil pump change" Questions

Ad

...oil pump. where can I find information as to what kind of a job (cost) this might be, or if this is something I could do over a weekend, thanks Bob. 1994 gmc sonoma 4.3lv6 non vortec 4.3L Engine To ...

Ad

Question about GMC Sonoma

1 Answer

...oil pump You have to remove the oil pan which may require lifting the motor a bit to get it out since the pick up tube for the oil pump goes into the deeper part of the oil pan. After you get the pan ...

Ad

Question about GMC Sonoma

1 Answer

oil pump and how do i change? Depending on oil type (IE: synthetic, etc) this is normal. If using conventional oil then I'd be concerned. To replace oil pump you'll need to remove pan and it is bolted

Question about GMC Sonoma

1 Answer

...pump relay in event of oil pressure loss. === When this switch is failing to provide the correct pressure to the ECU. The wiring harness can overheat and eventually create a short. ECM1 fuse blow is ...

oil pump on 2002 gmc sonoma 2.2 how i can take off oil pen do i need to take off the negine? In most cases no. But you have to loosen the engine enough to raise it up enough to get clearance to remove

vehicle warms up I changed the oil pump and still same problem could it be the bearings no its a bad ground . buy a book and check to wear the grounding block is and check for coarsen. or broken wire

...pump gets power THROUGH the OIL PRESSURE SWITCH. So get it running with your test wire, then disconnect your test wire. If it stalls out, then the oil pressure switch is either bad or

Question about GMC Sonoma

5 Answers

...oil pressure sensor Check the fuel pump relay and fuse.If the fuel pump relay is not functioning properly,the fuel will not flow as required.Also the fuel pump relay ground wire is connected to ...

oil pressure switch or the pcm, if the pump was still running as you say at the fuel filter . At terminals 85 and 86 of the pump relay, you could check for the computer signal on one of those with the

...a 1997 gmc sonoma? try to change oil pump and the motor wont raise You should have 1 on each side, just remove the bolts and jack it up until the distributor cap touches the firewall, Good luck, ...

Not finding what you are looking for?
1997 GMC Sonoma Logo

377 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 GMC Sonoma
1999 GMC Sonoma

403 Questions

1996 GMC Sonoma
1996 GMC Sonoma

359 Questions

1995 GMC Sonoma
1995 GMC Sonoma

270 Questions

1998 GMC Sonoma
1998 GMC Sonoma

269 Questions

1991 GMC Sonoma
1991 GMC Sonoma

241 Questions

Top GMC Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...