1996 GMC Sierra "suburban starting" Questions

1993 GMC 1500 suburban 350 engine will not start. Engine starter turns, ignition does not fire. i have a 1993 suburban gmc 1500. when i put the key in an turn it nothing happen at all.befor the car ...

My 1996 1500 Suburban with 5.7 revving high at start up? look in towards the idle air control valve which governs the airflow into the vehicle at cold start up - I suspect this is a possibility for a ...

2005 Suburban with vibration felt on the brake pedal and gas pedal while starting and driving at different speeds. Could possibly be a bad tire or front axle or drive shaft u-joints..

92 suburban stopped running at idle and won't start. Doesn't even try to ignite? Thought I might be out of gas. Gauge is unreliable. Put two gallons in. No spark. IGNITION MOGULE

i did a oil change on my 1994 gmc suburban w/5.7L and it started leaking oil on the back of the motor by the intake and the brass fitting for the oil pressure sensor. It is a steady leak and will lose

Good Evening, my 1997 GMC Suburban transmission started slaming into gear and code 1846. That code is for an encoder motor(shift motor) on the transfer case.Not difficult to change but expensive to ...

...problem truck turns over for a few seconds then just spins I had that same problem with my 2000 suburban. Be driven along just fine, then all of a sudded sputter, sputter, coast, coast. Then it ...

security light on GMC suburban will not let truck start on humid days until light goes off like half an hour later or so.It cranks over just not run. Maybe something connected to the ignition pump? Is

...to get it vaccumed because having too much coolent can make it not work at all. I had a 97' Suburban and the vent wouldnt open, in the ...

...The shaking "under a load" is likely a torque converter issue. I had the same problem on my 96 Suburban. Instead of rebuilding the transmission (or changing the torque converter), there is a ...