1996 GMC Sierra "1995 dies put" Questions

dies. When put in gear it dies immediately. I have replaced the IAC valve, MAP sensor, and fuel injection base gasket. Any ideas??? Hi, you've hit the usual causes. Now check for vacuum leaks and also

1995 GMC 5.7L TBI, I got the timing set and the truck to run but sputters out after a short time. If i press on the gas it seems to bog the truck down and put too much fuel in as it made a fireball an

...put a new fuel pump in, replaced the fuel filter and fuel relay with no luck. I am getting fuel up to the throttle body but it still will not start. There are two fuel lines going into the top of the ...

...Put new battery in it. Ran great for 4 weeks. Would stall once a week, but no problem restarting. Then the starter went out (it was free spinning), so I just replaced that. Turns over great. Now the ...

...Put new battery in it. Ran great for 4 weeks. Would stall once a week, but no problem restarting. Then the starter went out (it was free spinning), so I just replaced that. Turns over great. Now the ...

...dies. i just rebuilt the throttle body and put new throttle position sensor, air idle control ,and new injectors in it. not sure what to look for now other than a vaccum leak HI first I would like to ...

1995 suburban idles, but dies when put in drive. I can start my 1995 suburban, and it will idle just fine. as soon as i put it in drive and press the accelerator, it dies. it will start again with no ...

...1995 Transport dies when it gets warm. Why?? It will restart in park but dies when you put it in gear. Sounds like the torque converter clutch is locked up. Do you know if you have a three speed or ...

...1995 and a new clutch. The car Idles fine. When I put it in gear and let off the clutch to get moving the engine just dies on me. Even when I rev the engine just a bit, it still dies on me. Its not a ...

...dies when i put on the brakes i stop at a light it dies if i dont put on the gas at the same time or if i dont put it in park at a light and it dies did you get it fixed ? If not let me know I will ...