1989 GMC K1500 "signal hazard" Questions

signal relay and the hazard relay are the same type but don't say whether there is one or 2 in the circuit.. i have a similar problem but my left signal works, when i turn the right on it just does an

1996 gmc c/k1500 z71 4x4 my brake and hazzards work but my turn signal don't check the flasher first it may be bad, theres a flasher for hazards and one for signals start therefirst good luck.

...fuse. Replaced the 20 amp park light fuse and removed the broken plug which gave me my dash lights, signal and my hazards back but I still don't have rear running lights and brake lights and all the ...

hazard light button. Remove 3 phillips screws that hold the turn signal mechanical switches (you may have to flip the turn signal to the left to get to the bottom screw.) Remove the vanity plate under

...signal hazard combo switch. Did you check the TSIG/HAZ fuse in the rear fuse block ? The rear fuse box is under the rear seat ! Could be a problem with the turn signal/hazard flasher module. The ...

...the BCM. The turn lamps are permanently grounded. Replace the turn signal switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle in Steering Wheel and Column -

...Signal/Hazard Lamps The IGN E 10 A fuse in the underhood fuse block supplies battery positive voltage to the turn signal switch assembly. Ground for the hazard switch is from G302. The FLASHER 15 A ...

01 focus FYI 4dr haven't tried signal switch will b last where are the hazard and signal flasher combo located Check the hazard switch. If the hazard switch is not working, ur signal will not work....

...signal or hazard lamps, the SJB supplies voltage to the appropriate turn lamps. The hazard lamps are inoperative/always on Circuitry Hazard lamp switch SJB Go To Pinpoint Test O Pinpoint Test O: The ...

...signal or hazard. Hazard button out = turn signal works fine. I tried to eliminate the switch to see if that would help. If I disconnect the wire harness from the hazard switch, the turn signals will ...