1995 Ford Taurus "obd 1 location" Questions

OBD port The connector is under the hood on the passenger's side towards the firewall. It likely will have a cover on the plug labeled EEC TEST unless the cover has fallen off or been removed for some

...OBD Codes P0171 and P0174 Was getting fault code P0420, so I replaced all four O2 sensors with Bosch models. Also replaced plugs (Motorcraft platinum) and plug wires (Motorcraft). Car seems to run ...

...OBD-II code P500,(VSS fault) or P502 (VSS intermittent). My 1998 used to do the same thing when I left the driveway, but only in the morning. It would electricallly shift to neutral, I would put ...

...do I use for a '93 lincol MK Vlll 4.6 v8. obd-1 or obd-2 and where is the connection located Under drivers side dashboard near the steering column. Should be obd 1 as obd2 was not a standard until ...

1. Locate the OBD data link connector (DLC). Refer to your owner?s manual for the specific location. Tip: The OBD-I data link connector is usually located in the engine compartment near the battery or

OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 - 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated

OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 - 3 in the diagram below). If not located beneath the steering column, look for the port in the areas indicated

OBD 2 LOCATION 1995 JEEP GRAND CHEROKEE No obd 2 since it's a pre 1996 vehicle, so its obd 1. Start turning that key on-off-on-off-on, to get ck engine light to flash out codes.

...OBD 1 OR OBD 2 ? WHERE IS THWE LOCATION Obd 2 the connection is on driver side by kick panel I hand the same problem finding it! It's on driver side by kick panel I also recently bought a bluetooth ...

...obd 1 1990 was NOT OBDII, but it WAS an OBD or OBDI. OBDII (2), was not in use until 1996, actually late 1995 they started to appear, since mandate was for all North American vehicles to have them in ...