2001 Dodge Dakota "replace low oil sensor plug" Questions

replace, then No.2 etc. Test the running after and if problem still there, change the plugs 1 at a time to avoid mixing the leads up, test and if still there, change the cap and rotor, identify a mark

...replace the fan, the fan clutch, and, on max cooling systems, the radiator cap. (All) Exhaust backfire: Exhaust backfire and/or a popping noise in the exhaust may be caused by a defective Powertrain ...

...low oil level sensor electrical connector. 12. Remove the access plugs for the oil pan rear nuts. 13. Remove the following oil pan fasteners: 13.1. Remove the oil pan bolts. 13.2. Remove the two nuts ...

replace the camshaft. 13.Worn valve guides -- repair as needed. If the vehicle has low oil pressure perform the following tests. Check the oil level. Raise the vehicle and remove the oil filter. Start

...low volts (bank 2 sensor 2) All 4 oxygen sensors were recently replaced. The spark plug for cylinder 5 was broken and all spark plugs were recently replaced. I did have oil leaked into the cylinders ...

...Low> Replace Oil PUMP Obviously Inspect Wires To Sensor / Sensors Before High Dollar Parts Are Resorted to. If the rpm goes below 550 - 600 the maf sensor may be dirty or bad, change the spark ...

...replace the sending sensor and check they wiring Put oil in car ur just low on oil it will ho off when full This could be a lot of things. How cold is it outside. Do you have the right type of oil. ...

low oil pressure". My husband just flushed the cooling system and replaced the cooling temp sensor, could he have knocked something loose in the process? What else could be causing this message? It is

...low pressure light not a level light, have the oil pressure tested, don't drive it until u verify the oil pressure is ok, if it is replaced the oil pressure sending unit on the engine. before ...

...oil and it runs better, Don't waste you money on an ECM. Broken valve springs , leaky valve seats, if you know all this you should know you need to rebuild your engine and stop wasting you money, ...