...seemed to start doing this about the same time transmission was replaced, then I'd have installer adjust/test neutral safety switch at transmission for either being defective or just out of ...
...your throttle kickdown cable on top of the engine and to the right it needs to be pulled out and adjusted to you find the right spot and then it will shift correctly I do believe this will fix
having problems with my dodge durango not shifting properly For the person having shifting issues with your Durango I would say its the throttle " Kickdown " cable located on top of the engine and to ...
...up again. Your start and stall, and / or stall in reverse is a result of the "minimum air rate adjustment" needing readjustment to compensate for age and wear. The dealer changed your battery
...netural switch is bad and is held on with two bolts and takes 20 miutes to remove replace and adjust. Try holding the shifter firmly into park and see if it will crank or if it will crank in ...
...timing outside the zone of the rotor / plug contact.Find out what's wrong with the camshaft sensor. If there is a Problem Code it means there is a bad part or connection to the Cam Sensor. ...
adjust the ignition timing on the 2.5L V-6, a scan tool must be used to turn off the computer timing control to check and adjust base ignition timing. Base ignition timing specification is 4-6 degrees
...adjust the timing, I put in a new distributor because of the ignitor went out and I tried to adjust the timing to recommendations but I have no more play. go under the steering wheel and cut the red ...
set timing on a 1999 chevrolet blazer Timing is not adjustable, no distributor to adjust, only coil packs, which the computer determines the timing.
how do you set the timing on a 1999 mercury mystique ignition timing is not adjustable on your car. are you talking about camshaft/timing belt adjustment?
2,438 questions posted
Usually answered in minutes!
2,049 Questions
1,378 Questions
886 Questions
1,005 Questions
766 Questions