2001 Volkswagen Beetle "ox sensor code" Questions

Ad

Question about Volkswagen Beetle

1 Answer

...ox sensor bank 1 that the motor is running lean i replaced ox sensor , light was out for 10 miles than light came back on Check plugs see what they look like a lean mixture will look light in color ...

Ad

Question about Volkswagen Beetle

1 Answer

...sensor red lite on dash oxs sensor red lite stays on ! only started after i had the engine steamed cleaned .. put a new oxs sensor on and lite still on ? Did you clear the old code from the

Ad

Question about Volkswagen Beetle

2 Answers

...Ox sensor Bank #2 sensor 1. I replaced Ox sensor on passenger side of pickup and no joy error still remains. 2000 tundra V8 ran into this and it ended up cause of using an aftermarket o2 If you used ...

...ox sensors? If so is there a way to tell which one is bad? There should be 4 O2 Sensors, min The Codes DO tell you which one What the OBD2 Codes DO NOT TELL YOU, is that are bad That is the big ...

...OX sensor My 1997 service light came on autozone tested the code and said it was a bad OX sensor. It would shut off but I could start it with starter fluid in the port. Now will not start. Is there a ...

Question about Volkswagen Beetle

1 Answer

...sensor 1 ox sen replaced couple days ago. The check light cleared, then today, it came back on. Scan shows the same sensor again. Bad seating or bad o2 sensor? So what is the code? There is no code ...

ox heater circuit bank 1 sensor 3 code po147 which is sensor 3 Normally you have one sensor in front of and behind the catalytic converter. And most Ford products have two cats. On your Ford you may ...

Question about Volkswagen Beetle

1 Answer

trouble codes p0171, p1131, and p0136 p0171 = system too lean bank one. p0136 is a bad Ox sensor bank 1 sensor 2. You have at least one bad Ox sensor.

Question about Volkswagen Beetle

1 Answer

ox sensor. I replaced both sensors and the code reader still shows no input from the second (aft of the cat converter) ox sensor. I want to check the wiring however once the wires from the sensor goes

Question about Volkswagen Beetle

1 Answer

...ox sensor on manifold, and small idle motor on air intake. There are 2 problems for code 34. First, is manifold absolute pressure(MAP) sensor signal voltage low. Second, Mass Air Flow (MAF)sensor ...

Not finding what you are looking for?
2001 Volkswagen Beetle Logo

1,903 questions posted

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Bradley
Bradley

Level 2 Expert

105 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...