1999 Volkswagen Beetle "2 head" Questions

...bolts on a 2002 2 Litre 8V Cylinder head instructions Tightening sequence Renew bolts! Stage 1: Tightening torque = 40 Nm Stage 2: Tightening angle = 90 degrees Stage 3: Tightening angle = 90 ...

...2 SKIM THE HEAD IF ITZ WORPED !! MEANING NOT STR8T ... CLEAN IT AND LAY IT ON A FLAT SURFISIF IT LAYS FLAT THEN YA SAVEIN HOW EVA MUCH IT IS 2 GET SKIMED ROUND YOUR PLACE .. MAKE SURE YA PUT YA ...

...sequence for a 1970 vw 1600cc cylinder head. I have a 1970 Volkwagon Beetle,1600cc. Imagine that the head bolts are numbered from left to right.  Go 2-3-1-4 and set the wrench to 23

...HEAD NUTS AND CASES (2-SIZES ONLY) ALSO, TORQUE VALUE FOR THE ROCKER ARM. THANK YOU. THE LARGE HEAD NUTS, SHOULD SEALANT BE USED UNDER FLAT WASHERS? If I remember correctly, head bolts are set at ...

'62 1600cc VW ...Nbr 1/2 cylinders are not firing but get spark. generator appears to be dead. What might the problem be? The 1600cc Motors were prone to developing cracks in the heads between the ...

head and insuring timing correct, car ran for 2 days, then died ad now start up and un. Cranks over good but noelor spark. Relay for pump is good, Fuel pump good, fuses good, relay for fuel pump good.

...2 screws on the bottom but still feels like its held in by clips There are three T-25 head screws along the bottom of the inside door panel. Remove them. The face of the inside door handle is ...

2 bolts, the top one also secures the engine to the gearbox. The head of this bolt is a special D shape which engages into the body of the Starter motor. To undo, from the rear o/side wing, reach down

head lights are to low I have adjustment screw but they will only make the lights go side to side. there are 2 adjustment screws for headlight adjustment one for horizontal and one for vertical.the ...

wire either. is there any lights comming on on the control head? if not that may be the issue. there are 2 parts to the systems and mutiple powers. just give me some more info on it so i can help more