1996 Mazda 626 "crank position" Questions

...position of the crank on the new motor shaft. Trying to solve arc and park issues by changing position of wiper arms does not work. If I energize the motor and cycle it back to its park position, ...

...assume you mean crank shaft sensor ,if its not on the front puilley then look around the bell housing in the most extreme awkard in accessable position possible because you can bet that is where it ...

...crank it to it's original position and now it's stuck there. I can crank it, but it will only move around a little. What can I do? Front or Rear? By "crank" do you mean "push" or "rotate" The rear ...

My car got FS engine. it cranks but no spark on plugs.replaced another distributor still got same problem.supply is on connector. TESTING Disconnect the crankshaft position sensor wire harness plug. ...

...was running fine then all at once it shut off like the key was turned off i have checked for fire at the plug nothing it is getting good fuel pressure Crank Shaft Position Sensor is most likely ...

iget a code po335 code p0335 refers to crank shaft position sensor(CKP)- circuit -malfunction cause may include Wiring---CKP sensor Engine control module

...crank stay in position and slip timing belt back on (you can move the cam gear to get the belt on but make sure the marks are aligned after the belt is on). Last tighten the belt tensioner, I usually ...

...position sensor. It run down and bifircatres and has 2 sensors the plug into the block? well if it is the harness going into the timing cover, that is for you cam sensor, what plugs into the crank ...

...Crank Position Sensor (NE Signal). 03 Cam Position Sensor (SGC Signal). 05 Knock Sensor. 08 Air Flow Sensor. 09 Engine Coolant Temperature Sensor. 10 Intake Air Temp. Sensor (Air Flow Sensor). 12 ...

is there a way to test the ecm on a 1992 mazda 626 pcm wernt a big problem for mazda check your crank position sonsor and or cam position sensor hoped i helped