1994 Mazda Protege "cylinder" Questions

How do I know whether it is the slave or master clutch cylinder that is faulty My clutch pedal is stuck to the floor. How will I know if the problem is the slave cylinder there is air in the system ...

...hose replaced waterpump and hose now it wont fire It is very likely the overheating has blown the cylinder head gasket and coolant is getting into cylinders or compression is leaking from cylinder ...

...cod mazda tribute 2001 www.engine-light-help.com/generic-engine-check-light-codes.html P0302 - Cylinder 2 Misfire Detected Symptoms - Engine Light ON (or Service Engine Soon Warning Light) -

rear right brake cylinder dry there is no oil in rear right brake cylinder if your brake master cylinder has four separate lines to feed all four ...

misfire cylinder 00 mazda protage 00 mazda protage check engine light came on the code was check at autozone and they said misfire cylinder but just had sparkplugs(platniumplugs) and wires changed and

...the line from the reservoir to the transmission for leaks, unfortunately its most likely the slave cylinder in the bell housing. Look under the bell housing of the transmission for any brake fluid

no brake pedal I replaced the master cylinder, blead all 4 wheel cylinders and calipers. each time I pump the pedal I have to replace fluid but there is no fluid leaking from the cylinders or calipers

oil inside the #2 cylinder in a 2002 protege5 This could be caused by either: 1. Scratches in the cylinder wall, between the piston rings and wall. 2. A worn valve guide and seal. Add a can of Restore

...counterclockwise.  You may have to put the timing marks on TDC to know which wire terminal is cylinder one.  Cylinder one is the cylinder closest to the drive

...is binding up inside the case. If you have a hydraulic clutch system the replace the clutch slave cylinder and master cylinder as there is a problem with the rubbers in the units that have expanded ...