1992 Mazda Protege "causes pitting cylinder head" Questions

losing watger i have 92 mazda protege it was running hot,replace thermostrat still ran hot so took out.it loses water theres no leaks nhow.check water pump, hoses,where does water go.u have to put ...

...bubbles in my radiator. i have not pit my thermostat back in yet, is this causing my problem? what else would it be? A cracked cylinder head?? Head gasket not sealing due to a warped cylinder

...head gasket. The block did show some minor pitting but otherwise looked good. I started the engine and it started blowing white smoke after only running about five minutes. I removed the head and it ...

pitting corrosion is caused by prolonged operation under light knocking (detonation), Another insidious cause is cavitation when the coolant boils on the metal surface --too low a pressure cap for the

...cylinder head being warped. If you have no experiance in doing head gaskets then leave it to a pro as its such a big job and you can get it horribly wrong as you need to make sure you get the timing ...

what options are there if a spark plug constantly misfires, shots out of assembly and threads are striped? don't have the money to retap and drill the head, and i've tried connectors that fit on to ...

My 02 Camaro 3.8 has coolant in oil and white smoke could it be a water pump?.oil pump or is it only a head gasket issue? It has been sitting for a few months because I couldn't figure out why it had ...

...head gasket leak allowing combustion gases into the coolant. A good way to be sure is to take out all the spark plugs, pressurize the radiator with a tester and then wait a few minutes. Watch the ...

...them and your cylinder head is FUBAR! Use 'Anti-Seize' compound on the threads and use a torque wrench, set at specification, to tighten them ! ...

...causes and advance and precombust on that cylinder head and BAM it goes either you have a hole in the block, or hole in the piston or kinder yet a burnt exhaust or burn intake. Heres the fix remove ...