1992 Mazda 626 "head gasket" Questions

...head gasket went, had all new gaskets and skim, rebuilt engine, 250miles head gasket went again found out cause of prblem, re fitted gasket aswell as using instant gasket on the head. put all back ...

...head gasket? if so its about a week to do the job typically cause have to take heads off and can figure run into multiple problems along the way and need a new valve cover gasket cause it will fall ...

...head, head gasket, or block are leaking, no cream on oil filler, not using water and no film in radiator, what might be causing this, the car is a mazda 626 2litre dohc 97 with 80k Stage one of a ...

...head gasket, don't keep driving this you will do more serious damage than u already have. These are signs of a blown head gasket..And or a cracked head. POSITIVE It has a blown head gasket..When the ...

...I even fix this? The most common cause is a blown head gasket and sometimes a warped head. Someone would need to remove the cylinder head and have it checked for damage, then replace the head

re torqe head and rockers on mazda 626 2.2 turbo 1988 must remove head and change head gasket make sure matting surfaces are clean and free of old gasket materials

blowed head gasket not enough compression on a 99 madza 626 You need to remove the head and replace the head gasket. If you do not know how to do this then get a mechanic to fix your engine.

...head gasket blown, when engine is cold, remove rad cap and make sure rad is full, start engine and see if bubbles are pushed out of the rad filler spout, a blown head gasket will pressure up your ...

sometimes get white smoke outta the tailpipe i dont know if its the thermostat or head gasket white smoke is usaully bad sign of a head gasket gone bad have the system pressure tested,too check it out

...oil in coolent. how can oil go into coolent? blown head gasket maybe... 4 cylinder engine. did the vehicle over heat, a cylinder leak down test will pin point if you have a blown head