1997 626 clutch pedal dropped to the floor. will not shift.145000mil clutch has never been replaced u need a new clutch master cylinder an slave cylinder u have a fluid leak in the system You probably
how long to replace clutch in a 1998 mazda 626 For a 4 cylinder 2.0L engine flag time to remove and replace clutch 5.4hrs. For a 6 cylinder 2.5L engine flag time to remove and replace clutch 6.3 hrs. ...
...right all so assuming when u had transmission repaired u all so replaced (or at least checked) the clutch if clutch was not replaced when transmission was replaced it should have been unless clutch ...
1998 Mazda 626 clutch whining/grinding won't shift gears When you press on the clutch you get a whining and/or grinding sound and shifter won't go into gear? Was told possible throw out bearing. Does ...
does replacing the clutch and preasure plate on does replacing the clutch and preasure plate on a 1989 mazda 626 require the engine to be dropped and or removed? The clutch can be done by unbolting ...
My clutch in my 1990 mazda 626 has been giving me problems. The clutch was working perfectly fine, and then started getting stuck. As to where the clutch won't come back up after being depressed down,
how to replace the clutch master cylinder It says the brake and clutch master are the same one.here's a link on how to replace. SAVE 20 ON ONLINE SHIP TO HOME ORDERS OF 100 OR MORE Here are some new ...
Question about Mazda 626
626 5 speed manual transmission is stuck in a gear and won't shift out I lost compression in my clutch due to the seal on my master slave clutch in the floor board. It got stuck in a gear although
My clutch is still working althogh when i go to change gear i have to apply almost no pressure to the clutch it just goes down, then towards the end i have to push a little bit harder and i can get it
124 questions posted
Usually answered in minutes!
544 Questions
410 Questions
356 Questions
269 Questions
277 Questions