1988 Mazda RX-7 "3 brake pedal floor" Questions

...3 brake fluid that you use for your brake master cylinder, and make sure that you are pouring the fluid into the clutch master cylinder reservoir and not the rubber seal that should be under the fill ...

...brake reservoir cap. 17. Test the car brake system. The brake pedal movement no more than 1/3 of total stroke until the floor, when brake pedal is applied. Maximum admissible is 1/2 of total

...off rear flex hose and pedal is solid. Takes 2 > 3 pumps normally to get hard pedal then goes to floor, wouding in longer brake wheel cylinder pins would fix the problem???? P/S hope you can

...brake pedal to the floor and hold it on the floor. 3 when pedal is at floor tighten the bleed nipple up and get the person to let the brake pedal come up. 4 when pedal is up all the way undo bleed ...

3 TIMES AND THE BRAKE PEDAL STILL GOES TO FLOOR. You need to check wheel cylinders, the only way that the brake peddle will go to the floor like that is if there is a lose of fluid pressure somewhere

...still in the brake lines and need bleeding 2. if there are brake drums on the rear they may be out of adjustment 3. if there are warped brake disc or caliper problems that will add to the brake ...

...BLEEDING, REPLACED THE BRAKE BOOSTER AND THE ABS VALVE. BLED THE SYSTEM 3 TIMES AND THE BRAKE PEDAL STILL GOES TO FLOOR. have you blead the splitter to the rear brakes on the drivers side by the ...

...3 time then hold it to the floor, loosen the cap to let air out,but pedal still goes to the floor pump up pedal with bleeder locked 6 or 7 times slowly,hold pedal down crack bleeder pedal should sink ...

...on my mazda 3 go's all the way the brake pedal on my mazda 3 go's all the way down to the floor First check the fluid level. The next thing is to have someone check and bleed the brake

...THE BRAKE BOOSTER AND THE ABS VALVE. BLED THE SYSTEM 3 TIMES AND THE BRAKE PEDAL STILL GOES TO FLOOR. Check all the calipers and wheel cylinders The slave cylinder is the next thing I'd