...knock, the engine computer's response may have been to change the ignition timing on your engine. Knock sensors generally bolt into or thread into the engine block. This P0330 code may show up ...
... MG sorry to say knocking usually a rod knock--wrist pin-bearings-which means removing engine-also the engine cradle and front end dont let u drop the oil pan to get to the lower end of the crank ...
...van 3270000 klm, well maintained, oil level fine, when start up I hear a knocking noise coming from engine? When accelerating knocking noise is louder and quicker? Sounds like a rod bearing
...is located so that I can replace the part. Knock sensors are located on the engine block. Depending on what engine it is it might have one on each side. Here is a picture of the common Chevy
...knock in my engine when I excellerate or it idles. When it warms up its not as loud, I have used seafoam in the oil and gas to clean out the carbon build up. Oil pressure is at 275, and can't figure ...
ENGINE KNOCK 81 GMC 1500 (350) RECENTLY CHANGED OIL. AFTER ABOUT 200 MILES STARTED TO HEAR TAPPING NOISE LIKE IT WAS LOW ON OIL ,BUT IT WAS'NT. NOW IT'S STARTED A KNOCKING NOISE IN THE BOTTOM OF ...
why is the engine knocking worn engine componets or low octain gas. it could be a combination of both
...screwed into an access port, to verify oil pressure, but if it runs, does not tick, or knock, you may have a bad sending unit, mounted below the distributor, at the rear of the engine. Good
1998 gmc safari engine knocking You probably have a bad connecting rod bearing, broken piston, worn piston wrist pin, a bad lifter or rocker arm. You could pull the valve covers to see if anything is ...
Question about GMC Safari
Where are the ground points G105 and G107 for instrument cluster located? G105 In the thermostat housing G107 In the left rear of the engine block next to the knock sensor
159 questions posted
Usually answered in minutes!
316 Questions
254 Questions
265 Questions
207 Questions
197 Questions