Question about Cars & Trucks
...all 4 battery cables. What voltage that can not go through cable will go through meter. So the closest to zero is the best. good readings are .02 volts for connections and .05 volts per foot of
...battery terminals with engine off...Should be around 12.5 - 13 volts...Start the engine...Measure again...Should read at least 1.8 volts higher... Engine off...Set meter on X10 ohm scale...Measure ...
...volts DC...Take a reading across the battery terminals with key off...Then angle the meter so you can see it and turn the key to start...Record the reading...Send a comment with ...
...battery cable to its end and id find the starter. cant find it. looked here and read it cant be found because its stuck to the transmission housing or something. Now what? OK, even if you find the ...
...battery clamps/terminals for corrosion or looseness. with engine running, voltage with all ellectrical loads e.g. aircon, lights and with engine rpm set at 1500-1800, voltage should be over 13 volts ...
...battery. You want to be reading amps, not volts. That should give you a reading immediately of some current being used. While it's hooked up, start pulling fuses, one at a time. ...
Question about Mercury Cars & Trucks
...volts? Yes GO to A4 . No INSTALL a new battery ground cable. TEST the system for normal operation. A4 CHECK THE STARTER MOTOR GROUND Measure the voltage between the battery positive post and the ...
...battery (12-Volts dc) and transform that energy into a very high voltage charge (in the range of 30,000 to 35,000 volts) to energize the spark plugs which in turn ignites the fuel. If a spark plug or ...
...volts...Next, place + probe on the - battery post and the - probe on bare metal of the starter case...You must read less than .05 volts,,,If not the connections need to be removed and cleaned so bare ...
135 questions posted
Usually answered in minutes!
122 Questions
94 Questions
74 Questions
64 Questions
69 Questions