...and condenser. Follow lines and find second port this will be low side (refill) port. Paint or replace port caps (red high, blue low). Also, refrigerant in system determines port size (R12 or
...low side service port this is the one (port could be on compressor it will be the small port If the system is not evacuated first putting refrigerant into the system will be a waist of time. But the ...
...on it it is also near the condenser (can looking thing). The connections are different between high and low sides so you shouldn't be able to hook inot the high press side if refilling
...system. Now atatch the gauge hose to the low side with an unopened can of freon. now start the car and turn the ac on and turn the fan to full. check the gauge if it reads below the green then you ...
system is only a temporary fix. The leak needs to be permanently repaired. Regards, Tony Ummm that's the EVAP test port for vacuum testing NOT AN AC FILL POINT. Do NOT try to put anything in that port
...low side to 35-40psi (high side 225-275psi if the a\c system is in good shape) you wont have any problems. p.s. your low side port is on the accumulator\dryer under the pass. side fender. if you ...
...gage, when the low side pressure is at 28-32 PSI the system is charged, I think you are overcharging the system which loads up the engine and causes it to slow down. CHECK THE LOW SIDE
...system with the correct amount of clean PAG oil. Connect an R-134a A/C service center to the low-side and high-side service gauge port valves following the operating instructions provided by the ...
where is the recharge system to put in freon The low side recharge port in in the right front fenderwell on the accumulator. I hope this helps.
Location of Refrigerant Low side valve for charging system 02/03 ford zx5 focus follow the large ac line/hose untill u get to the small service port this is the one
1,815 questions posted
Usually answered in minutes!
3,749 Questions
2,612 Questions
2,055 Questions
897 Questions
840 Questions