Question about Ford F-350
...motor. Tighten the terminal nuts to 79 inch lbs. (9 Nm). 10. Connect the solenoid (S) terminal connector, if equipped with a starter mounted solenoid. 11. Install the starter solenoid safety cap. If ...
Question about Ford F-350
...plug there and if so do I have to pull the motor to replace it? ive done it,but you have to lift motor up and take mount off.its not fun and would have taken less time to pull it and replace them ...
Question about Ford F-350
Whats the best way to replace freeze plug behind motor mount on 97 s-10 with 4.3 L vortec engine support motor and remove motor mount
...replace a front motor mount on a 1993 Mercury Sable 3.0 V6 To change the right front motor mount on a mercury sable. 1. you will need a jack and 22mm and a 5/8 socket. 2. you want to place the jack ...
motor mount and tighten. 14) check again to make sure all is well and your done!These are the steps I took to replace mine. Only exception is I had a lift. Total time? 45 minutes. Drives like a champ.
...motor, examine the teeth of the flywheel for excessive wear or damage. Repair if necessary Fig. 11: If the old starter is going to be re-installed, check the condition of the pinion gear teeth. ...
Question about Pontiac Cars & Trucks
...replace fan resister on my 2000 pontiac Montana do I to take out the blower motor to get at the resister Step 1: Pry and remove the retaining pins (3) that secure the interior panel to the UNDERSIDE ...
Question about Cars & Trucks
...replace windshield wiper motor on a 1997 ford e250 van Wipers stopped working and I checked the fuses, and they were okay. REMOVAL Raise and support the hood. Remove the windshield wiper pivot arms. ...
Question about Chrysler Cars & Trucks
...replace the motor mounts on a 2006 chrysler pacifica with the 3.5 liter engine Look on youtube if there are any videos for that. I dont know your car but on same autos even qualified mechanics with ...
replace blower motor resistor. Was wondering if someone could tell me where it's located and how to replace it? its under the rt side of dash mounted to the heater box held in place by 2 5.5mm
568 questions posted
Usually answered in minutes!
448 Questions
438 Questions
414 Questions
311 Questions
293 Questions