2000 Ford Focus "remove battery housing" Questions

Ad

...remove the battery and the battery case to allow more room to have for a work space. Using pliers, squeeze the clip on the upper hose, and slide it away from the end of the hose. Release pressure on ...

Ad

...battery. You need a 10 mm wrench to remove the three bolts holding the housing onto the block. Removing the four hoses was the most difficult part. When they're off, the housing unit slides under and ...

Ad

...engine mount is unbolted ( 3 bolts, 19 mm I think ) and the engine is pried forwards. Once this was done, it would be pretty easy. Don't forget to remove the negative battery terminal before

Question about Ford Focus

1 Answer

...remove the battery cable & air filter box and remove 2 15mm bolts that go through the bell housing into the starter then get under the car and remove 4 10mm nuts & bolts that attach a plate ...

...Remove the battery hold-down clamp bolt and position the clamp assembly aside. WARNING: When lifting a battery, excessive pressure on the end walls could cause acid to spew through the vent caps, ...

...battery ground cable. For additional information, refer to Section 414-01.Raise and support the vehicle. For additional information, refer to Section 100-02.Detach the intake manifold bracket. Loosen ...

...remove the starter out of a 2003 ford focus? Removal 1. Disconnect the car's negative battery cable. 2. Raise the car's front end with its floor jack and support it on axle stands; make sure you set ...

Question about Ford Focus

1 Answer

...easy enough. repeat for the opposite side... im not sure about your car but with the st170 you have to remove the battery in order to replace the drivers side bulbs. i hope thats of some help to

Question about Ford Focus

1 Answer

battery and properly isolate to prevent accidental reconnection. Drain the cooling system. Raise vehicle. Remove or disconnect the following: Accessory drive belt shield Accessory drive belt Two power

Question about Ford Focus

1 Answer

...battery cable. Remove the push pins and remove the upper footwell panel from under the passenger side of the instrument panel. Unplug the connector from the blower motor resistor assembly. Insert a ...

Not finding what you are looking for?
2000 Ford Focus Logo

5,166 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Ford Focus
2001 Ford Focus

2,612 Questions

2003 Ford Focus
2003 Ford Focus

2,055 Questions

2005 Ford Focus
2005 Ford Focus

1,226 Questions

2004 Ford Focus
2004 Ford Focus

897 Questions

2006 Ford Focus
2006 Ford Focus

840 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...