...fan & outlets-vent,floor, windshield, etc.)except that dialing up the heat does not give warmer air; stays at ambient temp. I'm thinking the motor/solenoid that controls the heater blend door may be ...
fan unit 3 take a note of order of all wires, then cut the connector off. Same time on the resistor cut off the plastic that surrounding pins so you can easily work with pins. Only remove plastic that
...fan higher than two or it goes back to cold air. Also while driving my temp gauge is normal but when sitting at a stop light or idle it gets hot but not to redline. I bought a new thermostat and I am ...
...plastic tab you pull off of the side of the ECU(facing the door). A small toggle switch is behind it with 2 positions, "ON" and "DIAGNOSTICS". Using a small screwdriver or tool, move it to the ...
plastic bag...good luck do make sure fans are working as well If it is the 900 classic you are talking about (85-93 models) there are a few possibilities. First you need to look closley at the coolant
...plastic and tend to crack..although the most likely thing is the radiator fan relay..very common issue..(there are 2 primary and secondary) but if the tstat hasnt been changed you may wanna do that ...
fan dial? There are two screws at the very bottom, but are there clips, too? 1) The clock slides out by carefully prying with a fine screw driver. Take care not to scratch the dashboard fascia. It has
5,166 questions posted
Usually answered in minutes!
2,612 Questions
2,055 Questions
1,226 Questions
897 Questions
840 Questions