2000 Ford Focus "change line fuse alternator" Questions

...line? the alternator is a doodle to change ,when you know how ?? was it a new recon unit or a secondhand scrapyard job---- check for power to teh large terminal the start engine and disconnect neg ...

...line fuse or relay that might be stopping the system from charging? Changed alternator and wires, battery, and they are good but for some reason the alternator will not charge the battery im not sure ...

...line has melted all the holding clamps even when unplugged. Have changed the battery 3 times and the baterry cables and the alternator. Pulled the ABS fuse. Now the alternator isn't charging the ...

...line fuse for your alternator that may have been overlooked. It will be a orange and Lt blue on one side of the fuse and on the other side it will be Yellow and white. I hope this cure the problem. ...

...Fuse panel, not likely, could be tied into that light as well. Bottom line is somewhere along the line you are not getting the proper voltage. I would stop by a car parts store and have them check it ...

...line that goes from alternator to fuse box and its working. Have any advice??? When you have this problem ? When you drive fast or slow? When is cold,rainy...etc ? Been snowed in. Just drove that car ...

...change. i couldnt find the alternator fuse. can someone please help? It could be a very expensive mistake. Easy to destroy certain parts of the alternator that way. But even with a bad alternator, it ...

...fuse 2 times still burning out right away. need to know what could be the problem. Have a technician check out the battery, cables, alternator,wires behind alternator and the harness they lead to. ...

CHANGE OUT ANY ALT. IS TO PULL BATTERY NEG LUG, AND IF NOT DONE THE NOOB BLOWS FUSES FOR SURE THAT HUGE 100AMP FUSE. HARD TO FIX. SO JUMP STATED THE ENGINE STARTS. CABLE JUMPED AND BATTERY READS 13 TO

...change on circuit board after replacing the alternator Electronic power control(EPC). Its pretty important. Its not likely a fuse. Most likely you forgot a vacuum line or knocked a line loose. Check ...