2000 Ford Expedition "steering column parts" Questions

steering column. Could be a number of things from multi switch to a wire harness. Have vehicle checked by a professional someone you can trust. These things can be hard to pinpoint don't want to see a

the gear shift needle. reverse is now part and neutral is drive. vehicle is drivable but can this be adjusted from the transmission? It is a cable behind the steering column. Cheap and easy to replace

steering column. Use a drill bit or small pin to press on the spring loaded pin in the Ignition switch. When you pull up with the Ignition key, the lock cylinder should slide out. This is necessary to

...steering column that houses the flasher button and the turn signals. the ford dealer will have that part, but it will be expensive, not sure if it will be carried in an aftermarket store or not. try ...

steering column. We replaced the part where you put the key in and still nothing. :( re-check the electrical connections at the switch sometimes during replacement terminals become bent or even pushed

...a little tightening did the trick. Hope that is all that it is for you. Try replacing the flasher which is located underneath the steering column, this part will cost approx. $11.99, Good ...

steering column. Push it repeatively and sometimes it shakes the problem loose.The MFS has everything connected to it.  You will need to remove the plastic column cover, unplug the connectors and

...steering column on the firewall there will be a white box (6" X 3"). On the box is a label with part numbers and date codes. On that label you will see a 5 digit code printed a little darker than the ...

...steering column if it has cracked from not stepping on the brake pedal to get it out of park the shifter cable that's attached to it is not traveling as far as it should because the tube is partially ...

steering column, or is it the nuteral safty switch? Transmission range sensor code keeps comming up P0705after I replaced it. Try disconnecting the battery for 10 minutes and then see if the code goes