2000 Ford Expedition "1998 3 intake manifold" Questions

Ad

Question about Ford Expedition

2 Answers

1998 Ford Expedition stalls or boggs down when I accelerate. I've gotten atleast 3 different reasons. Mass air flow, O2 sensor or intake manifold leak. I don't want to spend money on all three. DO YOU

Ad

...Intake. Very rarely do these trucks actually need the valve replaced. But it is located on top of the engine,under that plastic cover that covers the throttle body. It is round, about 3 inches in ...

Ad

1998 ford expedition won't stay running, i can start it and as long as i keep my foot on the gas it will run, but when i move my foot it dies quickly Start with the vacuum hoses on the motor, this ...

...1998 Chevy blazer? Fig. 1: Intake manifold installation-4.3L engines (click over image for zoom) Fig. 2: Intake manifold bolt tightening sequence-1996-98 4.3L engines Install the bolts and tighten in ...

...1998 Nissan Pathfinder is as follows: 1. Locate the knock sensor. It is mounted on the intake manifold. 2. Disconnect the electrical connector from the knock sensor. 3. Remove the mounting bolts from ...

1998 KA24DE 1- Step 1: 22 ft. lbs. 2- 10-12 ft. lbs. plus 60-65 degrees or 28-33 ft. lbs. 3- The cylinder heads and the lower intake manifold are installed together 4- 10-12 ft. lbs. +60-65 degrees 5-

Question about Ford Expedition

1 Answer

...ON THE MAP SENSOR GOES The MAP sensor bolts to the intake manifold between the intake and the coil pack. The green 3 pin connector will go right under the manifold so you have only so far you can

...1998 ford taurus 3.0 intake manifold 3.0 engine TORQUE SPECIFICATIONSDescriptionNmLb-FtLb-InEngine Air Cleaner Tube Clamps1.6-2.2-14-19Engine Control Sensor Wiring Through Bolts2.5-3.5-23-30Generator ...

Question about Ford Expedition

1 Answer

...3 and number 5 cylinder. engine has good compression, cap and rotor CHECK WIRES TO THOSE CYLINDERS ARE THEY MIXED UP ..TRY RUNNING A FUEL SYSTEM CLEANER TO SEE IF IT HELPS CLEAR UP THE PROBLEM..ALSO ...

Question about Ford Expedition

1 Answer

...Intake Bolt Torque... Tighten in 3 steps: Step 1: 7.5 FT Lbs Step 2: 15 FT Lbs Step 3: 24 FT Lbs(to torque bolts & nuts, start in center using crisscross pattern) Hope helps (remember to rate and ...

Not finding what you are looking for?
2000 Ford Expedition Logo

3,327 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Expedition
1999 Ford Expedition

1,825 Questions

1998 Ford Expedition
1998 Ford Expedition

1,627 Questions

2003 Ford Expedition
2003 Ford Expedition

1,696 Questions

2001 Ford Expedition
2001 Ford Expedition

1,161 Questions

1997 Ford Expedition
1997 Ford Expedition

1,048 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...