...WINDSHIELD WIPER OFF THEY RETURN TO THE TOP INSTEAD OF THE BOTTOM. Fords seem to have a problem with that,try turning them off really easy,or slow and wiggle the turn signal switch.It could be a few ...
Question about Ford Crown Victoria
...windshield. Could this be a wiper motor issue, or is there an electronic control part that could be the issue? Return wiper control not giving power to return . I believe there was a video on u tube ...
...return back to the bottom it just stays in the middle of the windshield..Any thoughts on what may be causing this? Thanks Glenn either the start stop relay is goosed or the wiper censor has gone also ...
windshield wiper lifts up on return path I have put new wiper blades and refills on my lexus es300 and the driver side will clear the water on the upward sweep and then lift off the windshield on the ...
Question about Ford Crown Victoria
return and only work on fastest setting audi a4 1998 Use a 13mm wrench to loosen hex nut on wiper transmission, if this was previously adjusted. Ensure transmission linkages are parallel. tighten down
...bottom of the windshield the park mode of the wiper motor is malfunctioning. The most common fix for this problem is to replace the wiper motor. If you have the ability to disassemble the wiper motor ...
Question about Saturn Cars & Trucks
...windshield washer fluid? It does not spray fluid. There is a electric motor that pumps washer fluid . Located in the bottom of the washer fluid tank . Wash Operation (Front and Rear Wipers) The front ...
...windshield motor for my 2003 Land Rover Freelander and can't find where it goes, can you please direct me? The wiper motor is situated under the plastic air intake cover at the bottom of the wind ...
...return to the bottom of the windshield There is a "park pawl" on the wiper motor that has bent...you need to remove the wiper arms and plastic cowl to access the motor and either bend the pawl back, ...
I have a 2001 Mercury grand Marquis that the intermittent windshield wipers don't work. They work on high but won't return to the bottom position when turned off. it's probably the motor
721 questions posted
Usually answered in minutes!
486 Questions
323 Questions
297 Questions
294 Questions
301 Questions