is the starter hard to remove NO , USE A 10 MM SWIVEL SOCKET FOR THE BOTTOM AND SIDE BOLT ,,USE 10 SOCKET AND 4'' EXTENSION TO REMOVE TOP BOLT USE 8MM SOCKET TO REMOVE SWITCH WIRE AND 13 MM TO ...
Question about Ford Crown Victoria
... was running fine, just cut out.never started again jus driving along it cut out, stalled for about 10 mins, started back up got me home, stalled out again, and kept doing that for the day. would ...
1987 crwn vic 5.0 l, 302, Engine runs for 5-10 minutes and shut down. Cranks but will not restart. After 12-24 hrs car will start again and run for 5-10 minutes and process repeats. When the car shuts
...lid release solenoid, and LCM. For DDM removal and installation information, refer to Section 419-10 . Inspection and Verification WARNING: If equipped with fire suppression system, refer to
OR GROUND AND POSTIVE 12 Do you not have a multimeter or 12volt test light? Test light is about $5-$10 at autoparts stores & hardware stores
Question about Ford Crown Victoria
my 2004 crown vic gas milage dropped by 10 miles overnite was getting 23 mpg regularly now only get 15.5 mpg Is the check engine light on ?Could be a long list of things including sensors, air filter,
reset button Where is it located Car will not turn over Idk y I'm not familiar with any reset button, but I would check for an ignition fuse first. 10-20 amps
ODOMETER NOT WORKING, NO VOLTAGE FROM PCM, WHY REPLACED VSSM HOWEVER CHECKED VOLTAGE FROM PCM AND IT WAS LESS THEN HALF A VOLT. SHOULD BE A MINIMUM OF 10 VOLTS. NOW WHAT ? check speed sensor
how long is a crown victoria need to buy a car cover 17feet 10 inches long, 4 feet 10 inches high, 5 feet 10 inches wide.
dont know what fuse is for the stereo in a 94 crown victoria 10 or20 amp fuse on block under drivers side panel
430 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
301 Questions