...3 cylinder The coils are fired by the ECM, check all the wires to the ECM from the coils and make sure the signal is getting through and you don't have a wiring issue at the engine firewall connector ...
...3.0L V6 Intermittent ignition OK - For the last 10 years the Ranger has started perfectly every time. Last week, for the first time, I turn the engine over and it would not run. It sounded like none ...
...3 ohms. No opens or dead shorts. Next, I checked the crankshaft sensor for output by looking at the two terminals with an o-scope. While cranking the engine over I'll see a steady sine wave output - ...
Question about Ford Ranger
...3~knowing limits&threashholds{sensorsIGNcircuit}?Ty 0$ P0351 loss of power ? That's not what this code is about . P0351 - Ignition Coil A Primary/Secondary Circuit ,you have a bad coil and possibly a ...
...3 liter engine. I I have a 2005 ford ranger with 3 liter engine. I have a P1336 diagnostic code. The feedback I have read indicated this could be one or more or either the cam or the crank sensors. A ...
Question about Ford Ranger
...engine coolant temp (ECT) sensor--circuit malfunction=== causes --coolant thermostat---wiring short to ground--wiring short to positive ---ECT sensor code p 0122 refers to throttle position (TP) ...
...engine close to firewall, very difficult to get hand or tools on but is barely possible with deepwell 3/4" socket, extention bar and swivel knuckle, first need to get a finger on the release clip of ...
...engine light is'nt operating. i don't know if it ever did? what can i do? Hi, it's possible the bulb is burned out or not making good contact with the circuit board. It should come on ...
3 http://www.autocodes.com/p0318_audi.html Forum Code Possible symptoms - Engine Light ON (or Service Engine Soon Warning Light) - Engine Misfire - Engine Run Rough Read more: http://www.autocodes.com
...3 SPEC IS 17 - 18 OHMS FOR 2.0 ENGINE WIRING TERMINAL LOCATION LOOKING INTO VEHICLE HARNESS AT VALVE SIDE OF CONNECTOR 2--3--1 2= ORG 12 VOLTS KEY ON 3=GREEN/BLACK SIGNAL FROM ECM CLOSING CIRCUIT 1= ...
469 questions posted
Usually answered in minutes!
642 Questions
645 Questions
573 Questions
562 Questions
558 Questions