1995 Volkswagen Golf "clutch fork pivot" Questions

clutch throw out bearing problem It appears that the pivot arm shaft that pushes on the plunger that engages the throw out bearing has slipped off the spline. I need to remove this shaft to inspect it

...clutch fork pivot ball? 1992 Chevy C1500 2WD 4.3L V6 with 5-speed manual transmission. Transmission would not disengage. Took the transmission out and found that the pivot ball had pushed through the ...

...clutch fork is not moving clutch the same way each time you press clutch. Could be clutch needs play removed. Sometimes there is a pivot ball for the clutch fork to rest on. When the pivot ball is ...

...clutch fork push forward or pull back towards the cab.i don't seem to have a pivot point to see which way it should go.have no pics to see about clutch pedal to fork. You didn't say which clutch you ...

...clutch fork is worn will it still move in and out when I press the clutch also ifit does will it stop the car from going in to gear if your have a worn clutch fork in the pivot point of your fork it ...

...clutch got rock hard won't go into gear at all not Evan while not running uh oh, did they properly torqued down the pressure plate? they have to check the fork-throwout bearing area, which requires ...

...clutch slave fork too short Did it pop out of position or what? Or was this after you replaced the clutch or what? Well on clutch forks ive seen. There is a rounded stud sticking out and goes into a ...

...clutch fork are probably the cause of your noise. For a temporary fix you can try and peel back the rubber boot sorrounding the clutch fork and get some form of lubricant down there to get rid of the ...

...movement of the slave cylinder to release the clutch. I don't ever recall working on a throw out bearing actuator arm that has an adjustable pivot. Not saying there aren't any, but I've not seen

what do you call the stud that the clutch fork pivots on clutch fork pivot ball stud