2003 Pontiac Sunfire "washer fluid tank hold" Questions

...washer fluid tank. It rubs and the insulation wears and the wire corrodes. You will need to unplug the large connector below the battery and remove the ground screw located under the battery box. You ...

...washer fluid holds the rear. If your rear washer is not working, it could be one of 2 things..... 1- your washer fluid tank is low. Most car manufacturers design the tank so the rear washers stop ...

...washer fluid reservoir. This is normally located on the driver's side of the engine bay.Locate the fluid pump. It should be underneath the reservoir.Remove the bolts holding the pump to the vehicle's ...

Washer fluid is not spraying from front sprayers. The fluid levels are full. The back sprayer works. Are there two washer fluid pumps? It sounds like their is a noise when the back fluid is pressed ...

windshield washer resorvor won't hold fluid Check washer motor grommet/seal for leak, or rubber hose connection to sprayers at tank, or tank crack.

...pump if it is located in bottom of washer fluid tank? especially if it needs replacement? You have to pull the tank out of the vehicle ! should have just two or three screws or bolts holding it in

...is it? You have to remove the plastic tank you putthe washer fluid inThen you remove the motor or pump from the tankThe pump will be avail at a dealers parts counterOnly 2 to 3 screws hold the ...

washer fluid I already checked the fuse and that is not the problem. This is most likely the washer pump. I just replaced mine today. It is located on the right side, in front of the wheel, behind the

washer fluid pump, How to access tank and pump? 6 cyl, 4x4, fluid tank located on L. (drivers side) What you have to do is remove the battery and then remove the battery platform(what the battery sits

...washer tank will not hold fluid. Runs out at the bottom spout, I see no cracks. Is there a shut off on it? the washer motor is inside this reservior and the washer pumps seal is leaking on ...