replace plugs and wires, try starting it. Test the cam and crankshaft sensors and last the ignition coil-packs. If this is the 2.2, they're on the back of the engine and accessible from underneath. If
replace plugs and wires, try starting it. Test the cam and crankshaft sensors and last the ignition coil-packs. If this is the 2.2, they're on the back of the engine and accessible from underneath. If
replace it? 1990 Chevrolet Cavalier 2.2L TBI 4cyl The Crankshaft Position Sensor is located under hood, center, rear engine area, below ingnition coil pack and DIS module, mounted in engine block. Fig
Question about Pontiac Sunfire
...Crankshaft Sensor looks like this, ...
...replace it. need a diagram or where i can find it. The crankshaft position sensor should be located on a small metal bracket very close to the harmonic balancer which is attached to the end of the ...
Getting no spark and alredy changed coil packs and wires check crankshaft position sensor. Have you replaced the crankshaft sensor?If not replace it.If this does not help,replace the ignition module.
...replace the crankshaft sensor would cost $900, but I'm not sure of that because I priced the equipment and it averaged out to be $80. ...
...crankshaft position sensor, map sensor, ecm, and cleaned the fuel injectors. any ideas as to what is wrong? If your car is hesitating at 60 km, you may have any of these six problem-causes listed on ...
...Crankshaft Sensor are. I need to replace them!! on a 2-2 remove starter motor. disconnect sensor wiring,remove crankshaft mounting bolt and take out crank sensor. the sensor is located by the oil ...
...replace it 2.2L/2.4L Crankshaft position sensor is mounted on bottom of ignition control module, or near the ignition control module. The crankshaft position sensor protrudes through the side of ...
325 questions posted
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
696 Questions