Question about Nissan Cars & Trucks
...clutch went out in my 96 nissan pickup it will change gear aft it runs a while. If stop u have to turn the trk off to get it bcl in 1st or anygear I suspect an air in the hydraulic system or problem ...
clutch operating arm ,slacken bleed nipple on the slave then pull the bar back so it pushes the slave piston in.tighten bleed then release pressure on the bar ,and repeat a few times this should do it
...clutch slave cylinder. The latter is much less expensive and in some cars very easy to change (i did it myself on an old Mazda Rx-7 and I'm a girl!). Hope these suggestions help. adjust clutch or ...
...clutch master cylinder and the slave cylinder and bled the system there still is no clutch pressure You need to PRE BLEED the master cylinder, or you may never get pressure. Parts houses sell little ...
...there is either a slave valve problem,or clutch and/or pressure plate problem. It's cheaper to change the slave valve first, then take it from there providing the valve is external and not
...clutch arm and the slave plunger. Get it so you can push the plunger into the slave cylinder. Then open and close the bleeder. Pump the plunger back and forth and then hold it in. Open the bleeder ...
...slave cylinder is bled and that is the pressure plate. However, the clutch may have pressure, it dose not always engage the clutch all the way witch would cause a slamming of the clutch. Anothing ...
Question about Nissan Pickup
...clutch becomes stiff and it is hard to change gears, if at all. Fluid was low, had a pro fil it to the correct level. It did fine for about 2 weeks then the same thing happened except this time we ...
...slave cylinder,clutch.throw out ,and even syncronize the gears...come on!!! Heres the deal...when crusing... shifting into 2nd and 3rd it grinds as if the clutch isnt even engaged...if I pump the ...
549 questions posted
Usually answered in minutes!
829 Questions
564 Questions
428 Questions
319 Questions
286 Questions