1998 Mazda 626 "engines enable" Questions

i have a 98 monte carlo 3.1 auto trans. when i turn the key to start, the security light flashes and it does nothing I tried a second key and no luck. I found the tdm relay and i have current to the ...

1260 code wont start P1260 - This, basically is indicating that a theft has occurred, and the engine has been disabled.If the engine stalled, during travel, and the code was pulled after the stall, ...

99 explorer alarm disables. Motor dies Anti-theft system can keep vehicle from starting , Alarm is for vehicle content theft , open door without key alarm sounds (horns) ! PATS - passive anti theft ...

engine code p1309 P/S advice on repair The definition of this code is: P1309 Engine Misfire Detection Monitor not enabled It's a problem with the detection circuitry, not a detection of a engine ...

P1626 1997 chev silverado 1500 are they fix for this problem P1626 won't run DTC P1626 Theft Deterrent Fuel Enable Signal Not Received The control module communicates with other modules using the ...

What caused enable shut down message to come on my 2006 Lacrosse CXL and shut down engine. You have an actual message that says "enable shutdown"??

alarm and engine immobilizer system hi, i recently bought a used 2006 4runner (77000 km), very good condition. I dont know if is equipped with alarm and engine immobilizer system. Panic button at ...

I have a 2003 Chevy S-10 LS with a V6 4.3L engine, and recently my check engine light went on. I used my OBD II reader and it gave me codes P0016 and P0128. Now here is my dilemma, I replace the ...

I have a 2000 pontiac firebird the security light keeps flashing and my car want start unless you cross it over then it will start and run for a couple of seconds then it quits anybody have any ideal ...

the engine does not start, and start only when I open the TP sensor.After that when engine temperature reach to 80 C,the engine is starting.But idle was around 400 r/min your Tp sensor is faulty it ...