1997 Mazda 626 "manual shifting gears" Questions

2000 mazda 626 5 speed manual transmission is stuck in a gear and won't shift out I lost compression in my clutch due to the seal on my master slave clutch in the floor board. It got stuck in a ...

...manual, but no change. It still continues to flash. The transmission shifts fine through all the gears. Just can't get the O/D light to stop flashing you got to get the car on a scanner trasmission ...

...Manual: There are a set # of gears (usually 4-6) and you switch between them as required. Automatic: Again a set # of gears (usually 3-5), the transmission switches them automatically, based on ...

...two purposes, 1 not to let the engine start unless it is in park or neutral settings. 2 is when you manually switch gears, it tells the computer and the computer keeps the engine in check until you ...

...linkage is hung up or your transmission my be going out how does it shift while driving is it a manual or auto transmission and also check you transfluid it might below or dirty let me know what ...

wont shift into first or reverse sometimes works okay, but other times it stalls out and cannot get into gear. what type of transmission do you have automatic or manual

gearshift stuck in park read your manual could have a spot to insert a pin to mamually release or some now if you blow tail light fuse won't let it come out of park Gear shift stuck in park My suv is ...

...fluid in it to see if it is low? Will not down shift and only 2nd and drive is workin when i shift manually fluid is full and clean and not ...

...shifting to any gear. Wat can be the problem. check tranny fluid If manual transmission,check your clutch fluid and if low,your clutch slave cylinder is bad,is connected to side of trans.,with a hose ...

...gears stuck n reverse presumably its a manual box. Could be oil on the clutch plate. check if there is oil around the bottom of the housing or maybe dripping. if this is the case then you need a new ...