timing - or - Engine speed > 600 RPM with no EST pulses (ECM controlled timing) going to the ignition module for 200 msec. Typical causes for this code include: 1) BYPASS line is open or grounded 2
...timing before we reinstalled the engine. So other than any possible suggestions as to what the problem could be, I need to know if there is any way to udjust the valves on this particular engine ...
timing is set while the engine is running with a strobe light that is triggered by the number one spark plug. On this engine (if it's stock) around 8-10 degrees BTDC. The ignition timing advances with
...timing (front) cover from the engine. Lock the shoe on the automatic adjuster in fully retracted position by depressing the adjuster lock lever. NOTE: To remove the timing chain, it may be necessary ...
Engine How to put the timing on a 4.3L engine??? Can you elaborate? Timing chain? Distributor? 1998 sonoma 4.3
...timing chain. engine has 159,000 miles mostly highway.Haven't had any problems until now. I noticed in the fuse box there is a large square fuse labeled starter could that be the problem? maybe that ...
...AND FILTER.BESURE YOU HAVE TRANSMISSION FLUID LEVEL TO THE FULL MARK BEFORE DRIVING VECHICLE.LET ENGINE IDLE UNTIL GET WARM BUT CHECK TRANSMISSION FLUID WHILE ENGINE IDLING.IF FLUID LEVEL DROP A ...
...timing cover. The engine is now set up at #1 tdc on the compression stroke. Look at your distributor, there are three marks on it. An indent on the bottom of driven gear, A mark in between the two ...
...timing, engine overheating, carbon buildup in the combustion chambers, or low octane fuel.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and ...
359 questions posted
Usually answered in minutes!
403 Questions
359 Questions
270 Questions
269 Questions
249 Questions