...ignition module that is located on the distributor under the distributor cap, and that module is actually responsible for the fuel pump signal to run the fuel pump, the dwell signal to cause the ...
Question about GMC Suburban
...ignition module or pickup coil. The module is easier to replace - but the pickup coil is a wear item and the most likely fault. You could replace the module first and see if it starts or just replace ...
...ignition module [both are under the distributor cap] have to heat up quite a bit before they will act up. I replace about 10 ignition modules for every one pickup coil but either one can cause the ...
...ignition module , ingnition coil , distributar cab and rotor and it still won't start ! It has fuel , the code coming up is p1351 . Need help !!! Disconnect the ignition coil module connector. Probe ...
ignition module. 3 the pick up coil. In my experience the ignition module is the most common cause. It is in the distributor held in with 2 screws. The coil and module can be tested at any parts house
wont get gas to the injectors put a new fuel pump gas filter check the relays get sparks but wont start est circuit in ignition module replace ignition module
how to locate and replace ignition module how to replace ignition module 350 engine 5.7?
Question about GMC Suburban
...its an oil level sensor or oil psi sending unit but its actually called the electronic spark control module...not to be confused with the ignition control module which is attached to the coil ...
...start. Appears to be no ignition spark. I have checked coil and power to coil and replaced ignition control module. Still no spark out of the coil. Ideas??? Could be a bad ignition switch or ...
...ignition switch to the lock module Install the key alarm connector into the lock module assembly. Push the key alarm connector into the lock module assembly. Rotate the key alarm connector 90 degrees ...
1,320 questions posted
Usually answered in minutes!
273 Questions
225 Questions
157 Questions
68 Questions
73 Questions