...gear box . This can be due to failure of the linkages, the shifters , the counter wheels or gears. A fault in the gear box can be speculative and so unless the gear box is opened this cannot be ...
Question about Cars & Trucks
...gear box bolts, incorrectly tensioned bell housing bolts, spigot gearing failure in the input/ out put shafts or bearing failure for both shafts. After removing the shifter turret check the operation ...
Question about GMC Jimmy
...to side when its in the two wheel drive position if the shifter feels tight in the movement then I would suspect failed engine mounts and gear box mounts allowing excessive engine /gear box
Question about Daihatsu Cars & Trucks
...gear shifter on a daihatsu charade 2005 model My gear shifter has a lot of play between gears if it is a floor shift lever , there is a pivot pin in the lever ball / box tower that comes loose and ...
...gear I have a 99 golf, in reverse I have to keep my hand on the shifter otherwise it will pop out and grinding the gears, even sometimes with my hand holding the shifter it still does it anyway. does ...
...gear shifter is in your truck. Column or tower 2. Is the tail shaft turning when you try to move the vehicle 3. Does the vehicle try to move at all 4. Is there any noise from the gearbox or clutch ...
...gear shifter around for a minute or two I'm able to get it into gear but I know something has to be fixed. The little box that outlines the gear it's in isn't always visible as well. Any suggestions? ...
Question about Jeep Cars & Trucks
...gear box they can come loose and the lever doesn't pivot and so will not move the shifter rail Most likely internal problems. But you can pull the boot and then remove the shifter from the top of the ...
Question about Toyota Cars & Trucks
...and the gear shifter just moves up and down,and doesnt shift transmission You need to get under the hood or under it and check the linkage from the shifter to the box, likely something has come
...gear and then the shifter all of a sudden could move freely and i cant get it out of first gear like a pin or linkage brok. how do I fix this? If both cable ends are attached then the cable broke. ...
1,590 questions posted
Usually answered in minutes!
1,363 Questions
1,123 Questions
1,104 Questions
838 Questions
768 Questions