crank sensor? where is the crank sensor located? There was no crank sensor used for that year truck.
my truck hesitates to turn on If you crank it over for about 5 seconds and then stop cranking... then start cranking again... Does it start right up? This would indicate a weak fuel pump
...put another ( used ) engine in it (72,000) original on it . Every morning ,or after trying to crank it from a cold start it will not crank unless I spray starting fluid in throttle body , but ...
Question about GMC Suburban
my 1997 gmc 1500 suburban will not run but it pulls no dtc codes on the cpu i have change the crank shaft cencer change the full pump to brand new one new full filter new distribiter cap My 97 ...
1993 suburban won't crank when hot replaced starter, alternator and battery. After a long drive, won't start when hot. Usually cranks after cooling down. Now it won't crank at all. 290k on original ...
Motor cranks but won't start. The motor cranks fine but won't start. Actually, it cranks more smoothly if the coil wire is pulled off. It's almost like there is no spark or the spark is coming at the ...
...the fuel injection because it would vapor lock the motor. That seemed to fix it . But know its cranking and coming to a sudden hault. than it will crank again. I removeed the plugs and they were ...
1999 suburban , seems that the crank is knocking hard. was going to purchase a crank and rebuild. what do you think? It's proably a rod not the crank a crank noise would thump and be noisey on initial
Suburban slow to start. Turns over, but won't crank. Must "bump" the starter 6-10 times (easing off the ignition switch quickly) ...only way it starts. Then runs good and cranks good after ...
1996 suburban with 5.7l have good fuel pressure, sparks at the plugs, cranks with starter fluid but wont crank when i disconnect the crank sensor. when you say good fuel pressure is it 55 psi with the
391 questions posted
Usually answered in minutes!
921 Questions
225 Questions
157 Questions
68 Questions
73 Questions