Changing brakes and rotors I used to do my own brakes all the time on 70's & 80's era trucks. Are these brakes basically the same as before. Just compress the cylinder on the caliber insert new ...
...and you should be able to tell when its all the way up). now pull the cap off the distributer the rotor should be pointing at the #1 cylinder wire. if not then the distributer is in the wrong ...
Question about GMC K1500
...of the distributor that is faulty.When the engine is at TDC (Top Dead Center) is the ignition rotor pointing to the #1 position on the distributor housing as described below?The engine should
1989 GMC engine turns great , no spark at coil or plugs, had coil tested and repalced- new rotor and cap. not sure where to go next Check your fuses (ECM) and also recheck your wire leads to the coil.
...a distributor, is the ignition module. To replace the ignition module. Remove distributor cap and rotor. Remove the two screws that hold the module to the distributor. Once removed you will need to ...
random misfire in cylinder 1. plugs and wires are new. You can try changing the coils, rotor cap and distributor. See if that helps.
hi my 1998 5.7 misses on 2 4 6 8 cylinders random revit and black smoke runs rough at idle new plugs wires cap rotor maybe check that the shaft isn't bent in the distributor
how to keep a truck in time when taking out the destibutor on a 1991 gmc 305 tbi mark the direction rotor is pointing and then dont turn motor after removal
to die but it straightens out. Why is this? try replacing the spark plugs,wires,distributer cap and rotor(TUNE UP). also replce the fuel filter and air filter while your at it
engines fire order if you know the firing order, then get #1 on TDC, and then take the cap off, the rotor should be pointing forward, thats where number 1 wire should go
236 questions posted
Usually answered in minutes!
63 Questions
350 Questions
77 Questions
45 Questions
29 Questions