2003 Ford Crown Victoria "not working" Questions

it must be the fan fuse. If this does not work, you may have to replace your fan. Some cars fan would not start working right away; they would start working after you run the vehicle until it gets hot

...stopped, replaced fuse and relay, still not working. check temp sensors i believe there are two or three one under dash on both passenger and drivers side and one in middle under center of ...

...not it may save you some money and get it back working and working safely when they do the recall work on it. Ford did the recall due to the curise controls activating by them selves if I understood ...

...not working. Someone told me to check the ground. How do I do that. to check the ground, just run a wire from body of wiper motor to a good metal place on car body. or run wire to negative battery ...

...not working correctly strip out the heater panel around the control knobs and check the vent direction is working properly either stiff operation so a little wd40 on the cable would probably do the ...

...not working .. all other lights work includeding interior and rear lights..can someone help?/ I thought someone might have moved gas tank so I removed skid plate There could be a defect in the ...

...amp;#39;ll pretty much just list them as I know them. Head Lights constantly on if the car is on Cannot control headlights with the Headlight Switch Turn Signals do not work Hazards do not work Tail ...

2005 p71 left hi beam does not work 2005 P71 LEFT HI BEAM DOES NOT WORK. RELACED THE BULB AND STILL DOES NOT WORK. CAN I JUMP A WIRE FROM THE RIGHT SIDE TO THE LEFT SIDE TO MAKE IT WORK? Is a quick ...

...working but the next time i got in the parking lights did not work i found one bulb that was busted and replaced it and still nothin i checked fuses under the hood and inside and all are fine Did you ...