2001 Ford Crown Victoria "power mirror goes down" Questions

Power mirrors not working, have tried moving them manually (2001 Ford Crown Victoria). Both sides only goes down, not up. If the mirrors only move down and not up I would suspect the mirror switch , ...

...power mirror and I can't find the plug. Can anybody help? the plug is inside of the mirror housing once you take the old mirror out if you need to plug it after the housing and you replaced the whole ...

power mirror sideways (left to right) but not up and down. the motor is working. suspect cable or strap (or whatever) has broken.can't get to clips behind mirror to take backing cover off. adjust your

...goes down but up slowly power mirrors dont work at all The doors locks and mirrors may be a blown fuse. The window is simply a window lift motor that is either worn out and ready to go, or the tracks ...

...power to operate. The window, mirror, and radio switches are controlled with a wire that comes from one of the control modules. The wire goes to a switch in your dash. The power wire in the switch ...

...mirror assy. try moving in the up/down postions with you hand...could have debris jamming the gears inside. could be a loose connector in the power bezel. pop it off and check the connectors. went to ...

...power side mirror on my 2015 f150 it is tight to the door but the mirror shakes when I drive Probably the mechanism inside the housing is bad or at least loose. Is this a vehicle you bought used or ...

...power my auto-dim rear view mirror with compass. So I pulled the wires out of the snap-in plug that snakes up my windshielf and plugs into the bottom of the mirror, and I cleaned them. However, I ...

...power source grounding out, pinched wire. Good luck. Check your mirror motor...contacts could be loose or missing . As for battery draw, if your battery goes dead after only 5 minutes, check your ...

...mirror switch lights up on the dash board also I noticed a few weeks ago my power windows would'nt work with the drivers door opened. Anyone know what the problem might be ? Check the wire harness ...