...tank. Part of the float/pump assembly. Most instructions say to drop the tank, but I found it to be much easier to remove the bed. Which will fully expose the top of the tank allowing easy access to ...
...the tank is that low the pump screen could be sucking air but also accumalating debris that was floating in tank and partially blocking your fuel pump pickup
Question about Chevrolet Silverado
...tank of gas this is on a 2005 silverado Sounds like the float in the tank is faulty, or the gauge on the dash. You should be able to unplug the circuit to the sending unit and check both
the gauge alway shows high pressure even the car not running on 2004 chevy silverado 4.8 liter v8 FUEL SENDING UNIT FLOAT ARM STUCK UP POSITION IN FUEL TANK OR SENDING UNIT IN FUEL TANK FAULTY .
...pump module in the top of the tank and remove the fuel pump module being careful not to bend/break the fuel level sender float assembly. To do the above you have to remove the gas tank from the
TANK WITH A FLOAT AND ARM CONNECT TO IT.ALL YOU HAVE TO IS REMOVE FILLER NECK AND CAP.REMOVE VENT HOSE DISCONNECT TANK GAUGE WIRE AND GROUND LEAD.USE LARGEFLOOR JACK.PUT A PIECE OF PLY WOOD LARGE THEN
float/level sending unit. Depending on the vehicle, you may have to remove the gas tank. Had to replace the on in my wife's Pathfinder a few years ago and had to drop the tank to get to it. My Accords
....No low fuel light comes the float on the sending unit may be stock or movement restricted by dirt or vanish from fuel in tank remove and clean, if still having problem, replace sending unit ...
...tank from truck sitting a while,took it off and cleaned throuly,took fuel pump ,carb off cleaned also,got it to run great ,a week later started it up run bad ,back bowel is still dripping aftre you ...
886 questions posted
Usually answered in minutes!
1,100 Questions
795 Questions
393 Questions
396 Questions
296 Questions