...oil to the new pressure regulator O-ring and install the O-ring on the regulator. Install the regulator on the fuel rail. Apply thread-locker to the mounting screw. Tighten the screw to 106 lb in ...
oil pressure switch and its wiring. Repair as necessary and repeat the test. Also see figure 4 which is digram 3 from this link, this is the schematic on the fuel pump, the fuel pump's hot wire is tan
...oil pressure sensor electrical connector. Using J 41712 or equivalent, remove the oil pressure sensor. Using J 41712 or equivalent, remove the oil pressure sensor. To install: Apply sealant to the ...
Question about Cars & Trucks
...oil pressure gauge on a 2000 Chevy suburban with a 5.3L . find the electric pressure sender unit in the side of the block, unscrew it and install a "T" piece screw the electric sender unit back into ...
...oil pressure is good, he will then begin to diagnose the electrical pressure gauge system. If on the other hand, the mechanical gauge verifies the pressure is still low, he must diagnose the engine ...
...oil pressure sending unit gone bad.there is a couple of ways to check this problem. first if you have a real manual gauge i call them. this has a tube that goes in place of your electrical gauge.they ...
Question about Cars & Trucks
...oil. Disconnect the sensor electrical lead and unscrew the sensor. The sensor can be found on the top side of the engine, near the distributor. To install: Coat the first two or three threads with ...
...oil pressure somewhere in main port and use pressure gauge known good to compare against your electrical one you installed before freakin out about the high psi #'s you think you are ...
Question about Chevrolet Blazer
oil pressure sender unit is on the block install a "t" fitting . Place the electrical unit in one side and a brass fitting in the other . Run the copper line from the gauge through the firewall to the
...oil. Disconnect the sensor electrical lead and unscrew the sensor. The sensor can be found on the top side of the engine, near the distributor. To install: Coat the first two or three threads with ...
1,166 questions posted
Usually answered in minutes!
2,307 Questions
1,793 Questions
1,647 Questions
1,619 Questions
1,503 Questions