...drive shaft bolts to, then pinion will come out, there is also a crush sleve that will have to be replaced when it goes back together it goes over the pinion gear, thats for backlash ajustment when ...
...too much backlash,pull the drive shaft off the rear and tighten the nut JUST enough to take the backlash out near completely.Riger says,don't let the car roll while doing this.Block all
drive shaft and there was some play in the transfer case is this normal. Some play is required for normal operation, it is called backlash, it is more likely that if there is excess play it would be a
...drive side of a ring gear tooth (RING GEAR BACKLASH). Measure the backlash at 4 positions, 90 degrees apart around the ring gear. Locate and mark the area of minimum backlash. Rotate the ring gear to ...
...drive shaft like the other solution states it is backlash between the pinion and the ring gear in the front differential. I always check mine at the front of the driveshaft where it joins the front ...
...day. The noise you are describing is normal for landcruisers with some miles on them. The noise is drivetrain backlash, while it may not be in specification 100%, it is fine to continue driving. ...
...drive or reverse i hear loud noises in back of truck Sounds to me like you need to check your universal joints,or the backlash in the rearend,universals would be the most likely caiuse of the
...backlash in drive train appears to be between transfer case to front diff in 4th gear on bitumen when centre diff lock engaged no more backlash. mainly occurs when at a constant speed ie 70 to 90 ks ...
...drive shaft then open the differential to remove the carrier gear assembly(ring gear,side gears)then remove the pinion gear.replace these with the new gear set and get the clearance specs for the ...
661 questions posted
Usually answered in minutes!
878 Questions
795 Questions
754 Questions
575 Questions
561 Questions