1997 Chevrolet S-10 Pickup "replace front bearings" Questions

viberation in drive line truck has 7 u joints, replaced the 2 rear ones,vibe still there,but somewhat better. the rest of the seem to be ok is there a different shaft that would fit? at $50.00 a joint

...bearings were bad. You checked the front? so what does the rear axle oil have to do with that? you sure its not tires? if the tires are wearing irregularly, they will make noise. the noise is either ...

...that creates vacuum that could be going out? You might have the front wheel bearing assembly going out on you. I had a 1998 S10 that did that and I replaced the bearings and it was gone. Good

...front wheel bearings for a 2004 Chevy s10 pick up. IF YOU HAVE 4WD YOU WILL HAVE TO REPLACE BEARINGS.NOT ADJUSTABLE. IF YOU HAVE A 2WD YOU WILL REMOVE COTTER PIN AND LOOSEN THE SPINDLE NUT.SPIN THE ...

...replace the front wheel bearings and I can't get the wheel to go back on the spindle. What's the problem?? I take it this is a rear drive car, with normal tapered bearings? First of all, do you know ...

loud knocking noise in the front of my truck when i turn left,sounds like the frame of the front shock on the lft side but underneeth looks ok? Have you tried replacing the wheel bearing or track rod ...

...replace the conventional coil springs. The lower control arm attaches to the front end of the torsion bar. The rear end of the torsion bar mounts on an adjustable arm at the crossmember. This arm ...

...front driver side hub assembly replace and intake manifold replaced because of a coolant leak. Now under fast acceleration the tach bounces everywhere and causes the transmission to shift funny. Any ...

REPLACING FRONT WHEEL BEARING AND HUB dO i NEED A TOOL TO RELIEVE THE TORTION BAR TO CHANGE THE WHEEL BEARING? you do not have to relive tortion bar to replace wheel bearing and hub.

...replaced front wheel bearings, pinion seal was replaced several months ago have the tires themselves checked, it sounds like you have a tread coming lose , also, have you had the front end ...