1996 Chevrolet Suburban "neutral switch" Questions

Safety Neutral Switch Problem 1990 4x4 Chevy Suburban Silverado, 1500 half ton, 5.7 L engine How do I replace the Safety Neutral Switch? I assume manual? There should be a switch at the clutch pedal

...the park neutral saftey switch might need some lube. Remove the linkage and bolt on switch and find a wrench that fits on shaft. Spray rust inhibitor and work back and forth till it shifts

...? located at the bottom of the steering column. Mine is tricky, have to pull the shift lever while turning over to get it started. happened after i replaced ignition switch & Neutral Safety ...

to do with the linkage connection on the transmission some how but don't have any other ideas. shift tube in col? shift cable? check neutral saey switch, also shirwe socket (where shifter is installed

...SUBURBAN-NEW NEUTRAL SAFETY SWITCH,FUSES GOOD,BULBS GOOD move the gear selector back and forth between neutral and reverse, but not all the way. have the same problem u could have electrical ...

...neutral switch. make sure that the slots on the switch are lined up with the lower tabs on the tool. Rotate the tool until the upper locator pin on the tool is lined with the slot on the top of the ...

...switch. Try neutral instead of park, and make sure the clutch pedal is down if there is one. You could also have a bad battery or starter solenoid. Does anything else work and light up? Make sure the ...

replace neutral start switch does not start Are you getting power from the key switch to the starter ?

...it..If shifter is on steering column,,the cover will have to be removed,and the same buttonwill be visible...Replace the Brake neutral shift switch either way....about$37.50 and 3 hours work..Good ...

...neutral safety switch on 1992 Suburban located on steering column Under the dash on the steering column is a white piece that looks like a crescent moon. That piece is the neutral and backup switch ...