Question about Mazda MPV
...code is an S I am looking for the cylinder layout for my 2006 Mazda 6, the engine is a V6 3.0 liter, with a code letter "S" 1,2,3 are across the back under the intake and4,5,6 are across the ...
...Engine coolant temperature (ECT) sensor 6 Crankshaft position (CKP) sensor 7 Camshaft position (CMP) sensor 8 Knock sensor 9 Heated oxygen sensor (HO2S) (front, LH) 10 Heated oxygen sensor (HO2S) ...
engine? how many are there? Can we replace them by ourselves? It is mazda mpv 2000 Its in the center of each head f/r, in the front head it's in-front of the intake and on the rear it's at the rear of
...6 mos. ago. What does all this mean? The serviceman replaced a spark plug and reset check engine light to get us on the road. He said it could go out again anytime or even later like next year.... ...
engine light came on and was flashing. Parked van 2 hours. Drove 10 miles back and no problems. Can I move the coil pack to see if problem follows? Thanks. I have a corolla and had #4 cylinder misfire
...engine below the upper intake manifold. Remove the air cleaner box and use a mirror and you can see it. Only about 6 inches long. Replace both clips while you are in there because it is a bear to get ...
engine will need to be removed or the radiator and condenser will have to be removed to get access to the sensor and change it. No you don't have to move any of that you need a "crow foot" type oxygen
...engine and let it run for 6 to 8 minutes to reach, "normal operating temperature", and look for any leaking. before you turn the engine off turn your heater wide open and listen for a click. Most of ...
...engine idle. I pulled all the other wires and there was spark on 1/2/5/6. #4 wire had no spark also at idle. I am going to put the stock coil back in to check and see if there is a difference. As for ...
250 questions posted
Usually answered in minutes!
692 Questions
458 Questions
413 Questions
309 Questions
262 Questions