Question about Pontiac Sunfire
...fluid is low or empty. If the clutch goes out you still have the hydraulics to kick the pedal back. I would check for a leak anywhere between the master cylinder and the slave at the clutch. slave ...
...goes ok. I have observed no leaks. I'm hoping it's not the transmission, but instead in need to either clutch master cylinder or maybe even a new clutch. Any suggestions? Sounds like the clutch is ...
Question about Pontiac Sunfire
...for about 20sec and do it again it goes to the floor again....... There is either air in the system or a leak in the clutch slave cylinder. Check your fluid make sure it is full and the cap is
...fluid level is good but no hydraulics the clutch just goes to the floor Your Slave Cylinder is bad, it is not holding pressure causing your clutch pedal to not work, it located on the driver's ...
...fluid goes in a 1996 sunfire? Put brake fluid in,bled it. wont work. Dot 3 oil. HYDRAULIC CLUTCH BLEEDING 1. Clean cap. Remove reservoir cap and diaphragm. Fill reservoir and keep full throughout ...
...fluid level is good and the clutch travel before it engages is good.do you have an idea what might have caused this¨glitch¨. Your clutch master cylinder sounds like it had bound up, You ...
...goes soft. "Pumping it up" circulates fluid through the system and gets a normal amount of fluid "under" the piston again, so it feels better again, but when you press, it starts all over again. Good ...
Question about Cars & Trucks
...goes all the way to the floor Your clutch fluid reservoir may need brake fluid-yes, it uses brake fluid as a hydraulic fluid. Check reservoir on the firewall. It will sit beside the brake master ...
Question about Toyota Cars & Trucks
is where the fluid goes. Uses brake fluid, just like the brake master cylinder, also on the firewall. The clutch master only has one line coming from it-the line that goes to the clutch slave cylinder
...goes over to the clutch master cylinder, if fluid level is not above this hose the clutch will stop functioning. If the clutch slave cylinder, mounted on the front side of transmission bellhousing, ...
657 questions posted
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
696 Questions