2004 Pontiac Grand Am "torque specifications bolts" Questions

main bearing torque: http://www.autozone.com/autozone/repairinfo/specifications/specificationsMain.jsp?categoryNValue=25199999&categoryNameForTitle=Internal+Engine&categoryName=Internal+Engine

...Torque the bolts to 24 ft. lbs. (32 Nm). - Rocker arm cover using a new gasket. Torque the rocker cover bolts to 89 inch lbs. (10 Nm). - Heater bypass pipe. Torque the screw at the water pump to 106 ...

torque setting for the front disk brake rotors The rotors are not bolted to anything, they are sandwhiched between wheel & hub. Therefore there is no specification for them. Caliper bolts are 38lbs if

...torque! Head bolts--------- 22 ft lbs. Intake upper------ 18 ft lbs. Intake lower------- 10 ft lbs. Tighten vertical bolts first, the diagonal bolts, failure to do this will result in an oil leak. As ...

...note the length of the head bolts in case some are long or short so you can replace them in the correct place. Fit in the new head gasket, replace the bolts, and torque to the factory

...Torque the bolts to the required specification. Clean any rust or dirt from the mounting surfaces of the steering knuckle and the hub/bearing. Using a new O-ring, install the new hub/bearing to the ...

torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems. Install the

...Torque all bolts to the following specifications after all bolts have been inserted and hand tightened: the chain housing nuts to the pump assembly to 19 foot pounds (26 Nm), the water pump assembly ...

...torque adjust or porcedure to take off? For 1994 Pontiac Grand Am 3.1L SFI OHV 6cyl check this procedure for Intake Manifold... (see Figure 14) The 3.1L engine is equipped with upper and lower intake ...

...later. Use an impact wrench that has torque settings. An ordinary torque wrench is difficult to use as the motor wants to turn. Use the torque settings from a list of specifications for your